Altinex Stereo Receiver DS801 111 User Manual

SPECIAL APPLICATION  
MANUAL PART NUMBER: 400-0442-006  
DS801-111  
INTERA® COMPUTER/COMPONENT  
VIDEO+ STEREO AUDIO  
TWISTED PAIR (UTP) RECEIVER  
 
SPECIAL APPLICATION  
1.4 FCC NOTICE  
PRECAUTIONS / SAFETY WARNINGS  
1
·
This device complies with Part 15 of the FCC  
Rules. Operation is subject to the following two  
conditions: (1) This device may not cause  
harmful interference; and (2) this device must  
accept any interference received, including  
interference that may cause undesired  
operation.  
Please read this manual carefully before using your  
DS801-111. Keep this manual handy for future  
reference. These safety instructions are to ensure  
the long life of your DS801-111 and to prevent fire  
and shock hazards. Please read them carefully and  
heed all warnings.  
1.1 GENERAL  
·
This equipment has been tested and found to  
comply with the limits for a Class A digital device  
pursuant to Part 15 of the FCC Rules. These  
limits are designed to provide reasonable  
protection against harmful interference when the  
·
Qualified ALTINEX service personnel or their  
authorized representatives must perform all  
service.  
equipment is operated in  
a
commercial  
1.2 INSTALLATION  
environment. This equipment generates, uses,  
and can radiate radio frequency energy and if  
not installed and used in accordance with the  
instructions found herein, may cause harmful  
interference to radio communications. Operation  
of this equipment in a residential area is likely to  
cause harmful interference in which case the  
user will be required to correct the interference  
at his own expense.  
·
To prevent fire or shock, do not expose this unit  
to water or moisture. Do not place the  
DS801-111 in direct sunlight, near heaters, or  
heat-radiating appliances, or near any liquid.  
Exposure to direct sunlight, smoke, or steam  
can harm internal components.  
·
·
Handle the DS801-111 carefully. Dropping or  
jarring can damage the unit.  
Do not pull any cables that are attached to the  
DS801-111.  
·
Any changes or modifications to the unit not  
expressly approved by ALTINEX, Inc. could void  
the user’s authority to operate the equipment.  
1.3 CLEANING  
·
Clean only with a dry cloth. Never use strong  
detergents or solvents, such as alcohol or  
thinner. Do not use a wet cloth or water to clean  
the unit. Do not open the unit to clean.  
400-0442-006  
2
 
SPECIAL APPLICATION  
ABOUT YOUR DS801-111  
2
TECHNICAL SPECIFICATIONS  
3
Specifications are subject to change.  
See www.altinex.com for up-to-date information.  
DS801-111  
Intera Twisted Pair (UTP) to Video +  
Stereo Audio Receiver  
FEATURES/  
DS801-111  
DESCRIPTION  
The DS801-111 provides a means of receiving  
computer video and audio signals over  
Twisted Pair-type (CAT-5/6) cable when used  
together with a compatible ALTINEX Twisted Pair  
(UTP) video transmitter, such as the DS801-110 or  
DA1930CT.  
GENERAL  
Inputs  
Video+ Stereo Audio  
Power  
RJ-45 female (1)  
2-pin terminal block (1)  
The DS801-111 is compact and easy to use. The  
DS801-111 is able to receive either computer video  
or component video along with stereo audio  
transmitted over the UTP cable from the  
DS801-110 or an equivalent transmitter.  
Output  
Video  
15-pin HD female (1)  
3.5 mm female (1)  
Stereo Audio  
Compatibility  
Signal Types  
The DS801-111 provides both video and stereo  
audio outputs. The DS801-111 offers a female  
15-pin HD output for RGBHV/YPbPr signals with  
native Plug & Play compatibility and a 3.5 mm jack  
is used for the stereo audio output.  
ALTINEX Standard for  
Twisted Pair  
VGA through UXGA  
480p through 1080i  
Video Signal  
Resolutions  
The unit also offers video equalization hardware for  
long transmission lengths. There is also a Signal  
Detect feature that shows when an input signal is  
present.  
VGA:  
640x480@60Hz  
900 ft (274 m)  
Recommended Max.  
Cable Lengths  
Note: Measurements  
made using ALTINEX  
low-skew cable,  
XGA: 1024x768@60Hz  
700 ft (213 m)  
The latest generation of Twisted Pair devices uses  
an innovative, patented technology* developed by  
ALTINEX. The new signal processing technology  
allows transmitting and receiving fully equalized  
computer video signals, stereo, and audio signals  
over long distances.  
SXGA: 1280x1024@60Hz  
650 ft (198 m)  
CB3150PV.  
UXGA: 1600x1200@60Hz  
600 ft (183 m)  
Accessories Included  
Power Adapter  
(with 50 ft (15 m) cable)  
* US Patent 7,065,190  
+9 VDC, 500 mA  
Table 1. DS801-111 General  
400-0442-006  
3
 
SPECIAL APPLICATION  
MECHANICAL  
Housing  
DS801-111  
0.036” Aluminum  
0.035” Steel  
ELECTRICAL  
Input  
DS801-111  
Video/Sync/Audio Signals  
ALTINEX Standard  
Front Panel  
Length  
Video+ Stereo Audio  
4.10 in (104 mm)  
1.38 in (35 mm)  
1.20 in (30 mm)  
0.25 lb (0.11 kg)  
10°C-50°C  
Output  
Width  
Video Analog Signal  
Video Sync Level  
Audio Level  
1.0 Vp-p max.  
TTL  
Height  
Weight  
0 dB +/- 0.5 dB at 1 KHz  
T° Operating  
T° Maximum  
Humidity  
Power Consumption  
External Adapter: 9 VDC  
75°C  
410 mA (3.7 W) max.  
90% non-condensing  
38,000 hrs  
Table 3. DS801-111 Electrical  
MTBF (calc.)  
Table 2. DS801-111 Mechanical  
400-0442-006  
4
 
SPECIAL APPLICATION  
PRODUCT DESCRIPTION  
4
VIDEO  
EQUALIZATION  
POWER/SIGNAL  
PRESENT LED  
VIDEO OUTPUT  
AUDIO OUTPUT  
4TP INPUT  
POWER  
400-0442-006  
5
 
SPECIAL APPLICATION  
APPLICATION DIAGRAMS  
DIAGRAM 1: TYPICAL SETUPS  
5
DS801-110  
DS801-111  
DS801-111  
400-0442-006  
6
 
SPECIAL APPLICATION  
DIAGRAM 2: INTERNAL VIEW  
DS801-111  
POWER  
2-PIN TERM. BLOCK  
9 V, 500 mA  
PS  
LEFT  
LP  
LP  
UNBAL.  
AUDIO  
STEREO  
3.5mm  
AUDIO  
SEPARATOR  
PAIR 4  
RIGHT  
SIGNAL  
DETECT  
POWER  
4TP  
RJ-45  
V
SYNC  
SEPARATOR  
H
COMPUTER/  
COMPONENT  
VIDEO  
PAIR 2  
PAIR 3  
PAIR 1  
R/Pr  
15-PIN HD  
B/Pb  
G/Y  
H/W  
EQ  
400-0442-006  
7
 
SPECIAL APPLICATION  
INSTALLING YOUR DS801-111  
6
OPERATION  
7
Step 1. Determine the best location for the  
DS801-111. Where possible, locate the  
TP Transmitter as close to the video  
source as possible and the DS801-111 as  
close to the receiving component as  
feasible.  
The DS801-111 requires only one adjustment to be  
made for optimal performance. The adjustment is  
video equalization for long cable lengths.  
7.1 VIDEO EQUALIZATION  
Video equalization is provided to fine-tune the  
displayed image on the remote display.  
Typically, for short cable runs the equalization  
will be set to near minimum.  
Step 2. Apply power to the 2-pin terminal block on  
the rear of the DS801-111.  
The  
Power/Signal Present LED should be on  
and red.  
Start by setting the equalization to minimum on  
both units. Adjust the equalization on the  
receiver first. This adjustment should at least  
allow the receiving display to receive an image.  
Then use the equalization on both units to  
fine-tune the image for optimal quality.  
Step 3. Connect the receiving display to the  
output of the DS801-111 using  
a
high-quality video cable.  
Step 4. Connect the audio amplifier or speakers  
to the audio jack on the DS801-111.  
TROUBLESHOOTING GUIDE  
8
Step 5. Run a UTP-type (CAT-5/CAT-5e) cable  
from the 4TP INPUT on the DS801-111  
Receiver to the 4TP OUTPUT on the TP  
Transmitter.  
We have carefully tested and have found no  
problems in the supplied DS801-111. However, we  
would like to offer suggestions for the following:  
8.1 NO DISPLAY  
NOTE: Ensure good signal transmission  
by routing the cable to avoid any  
sharp angles, creases, or bends.  
Cause 1: The source has a problem.  
Solution: Check the source and make sure  
there is a signal present and all  
source connections are correct. If  
the source is working and there is  
still no display, see Cause 2.  
Step 6. Connect the TP Transmitter per its  
installation instructions. In the case of the  
DS801-111, when the TP signal from the  
DS801-110 is applied, the Power/Signal  
Present LED will turn from red to green  
indicating a signal is present.  
Cause 2: The path has a problem.  
Solution: Connect the transmitter directly to  
the receiver using a short UTP  
patch cable. If the image is good,  
there is a problem with the cable.  
Otherwise, see Cause 3.  
Step 7. The units are now operational.  
Cause 3: Cable connections are incorrect.  
Solution: Make sure that cables are properly  
connected. Also, make sure that the  
continuity and wiring are good. If  
there is still no display present, see  
Cause 4.  
400-0442-006  
8
 
SPECIAL APPLICATION  
Cause 4: Video equalization required.  
ALTINEX POLICIES  
9
Solution: Adjust the VIDEO EQUALIZATION  
on the DS801-111.  
9.1 LIMITED WARRANTY/RETURN POLICIES  
Please see the ALTINEX website at  
www.altinex.com for details on warranty and  
return policies.  
Some monitors are very sensitive to  
signal quality and this may prevent  
the monitor from displaying an  
image until the equalization is  
adjusted. See the operation section  
for adjustment details.  
9.2 CONTACT INFORMATION  
ALTINEX, Inc.  
592 Apollo Street  
Cause 5: The display has a problem.  
Brea, CA 92821 USA  
TEL: 714 990-2300  
Solution: Make sure the display is powered  
and is turned on. If there is still no  
display, please call ALTINEX at  
(714) 990-2300.  
TOLL FREE: 1-800-ALTINEX  
8.2 NO SOUND  
Cause 1: The source has a problem.  
Solution: Check the source and make sure  
that there is a signal present and all  
source connections are correct. If  
the source is working and there is  
still no sound, see Cause 2.  
Cause 2: The volume is too low.  
Solution: Increase the gain at the source. If  
there is still no sound present, see  
Cause 3.  
Cause 3: Cable connections are incorrect.  
Solution: Make sure that cables are properly  
connected. Also, make sure that the  
continuity and wiring are good. If  
there is still no sound, see Cause 4.  
Cause 4: The receiving device has  
problem.  
a
Solution: Make sure the receiving device is  
powered and is turned on. If there  
is still no sound, please call  
ALTINEX at (714) 990-2300.  
400-0442-006  
9
 

3M Refrigerator 965AMS User Manual
Acroprint Time Clock ES900 User Manual
Adcom DVD Player GDV 870 User Manual
Aiphone Home Security System AC 10F User Manual
Alpine Automobile Alarm SEA 8081 User Manual
Alpine Flat Panel Television TME M580 User Manual
American Standard Indoor Furnishings 0131012 User Manual
Audiovox Remote Starter APS 57N User Manual
Avocent Switch SwitchView User Manual
Axor Sprinkler S 350 AIR User Manual